Click image to view full size image
■ Application: | |
Mini Shrink Soldersleeve with heat-shrinkable radiation cross-linked modified polyolefin insulation.Transparent insulation sleeve provides encapsulation,inspect, strain relief, and insulation.Pre-fluxed solder provides controlled soldering process. One piece design, it consists of transparent heat shrinkable sleeve and fluxed solder. Provides insulation and lower the installed cost. Color hot-melt glue on two ends of heat shrinkable tube, connecting wires to component terminals, such as motor tabs, connector pins, and switch terminals, it is very convenience to use the exact wire dimension. | |
■ Characteristics： | |
|
●Shrinkage ratio 2：1
| |
■ Technical Data: |
|
| Operating temperature | -55℃~125℃ |
| voltage Resistant | ＞600V |
| Protection type | IP67 |
| Volume Resistivity (Ω cm): | ≥10 15 |
| Dielectric Strength (KV/mm) | ≥25 |
■Size |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
| Product Code | Dimensions(mm) | Selection Guide(mm) | |||
|---|---|---|---|---|---|
| L max | ΦDmin | ΦD1min | ΦCable max | ΦCable min | |
| HP-SWT-MC | 18,54 (+/- 1,27) | 1.52 | 0.70 | 1.5 |
0.76 |
Other sizes are available upon request.
●Item 1 : Heat shrinkable Sleeve , Transparent ,Radiation cross-linked modified polyolefin.
●Item 2: Solder Ring with flux
●Item 3: Glue rings
■Color:
Standard color: White, Red, Blue,Yellow
Other colors are available upon request
